Open 7 days · Same-day appointments · Serving Columbus & nearby suburbs(380) 666-6240
(380) 666-6240
Torsion & extension springs

Garage Door Spring Repair in Columbus, OH

If you heard a loud bang from the garage and now the door won't lift, a spring has almost certainly snapped. Springs do the heavy lifting, not the opener, so a door with a broken spring is heavy, unbalanced and unsafe to force. A technician can usually replace it the same day.

Technician tightening a garage door torsion spring with a wrench
Know the signs

Signs your spring has failed

  • A loud bang from the garage

    Torsion springs release their tension all at once when they break, which sounds like a firecracker or a dropped plank.

  • The door lifts a few inches, then stops

    Openers have a safety limit and give up when the door is far heavier than expected.

  • A visible gap in the spring above the door

    On torsion systems you'll see a 1–2 inch separation in the coil on the bar above the door.

  • The door slams or falls fast when closing

    With no spring counterbalance, gravity takes over. Keep people and cars clear.

Torsion vs. extension springs

Most homes around Columbus built in the last few decades use torsion springs, mounted on a steel shaft above the door. Older homes and some single-car garages use extension springs that stretch along the horizontal tracks on each side. Both store enough energy to lift a door weighing well over a hundred pounds, which is exactly why they're dangerous to adjust without the right tools and training.

Why springs break

Every open-and-close cycle fatigues the steel. Standard springs are commonly rated for around 10,000 cycles, which for a family using the garage as its main entrance can mean several years, or fewer. Rust, Ohio's cold winters and a door that's out of balance all shorten that life. When one spring breaks, the other has been through the same number of cycles, which is why replacing them as a pair is usually the better value.

Getting the size right matters

A spring is matched to your door's weight and height by wire size, inside diameter and length. The wrong spring leaves the door drifting open or crashing shut and strains the opener. A proper repair measures and weighs the door, fits the correct springs, then balances it so it stays put when lifted halfway by hand.

What affects the price

Every door is different, so the technician confirms the exact price on site before any work starts. The main factors are:

  • Torsion or extension system
  • One spring or a matched pair
  • Spring size and cycle rating
  • Whether cables or bearings also need replacing
How it works

What to Expect on the Visit

Secure the door

The door is clamped in place so nothing moves while tension is released.

Measure and match

The old springs are measured and the door's weight is checked so the replacements fit.

Replace and wind

New springs go on with proper winding bars, never screwdrivers or makeshift tools.

Balance and test

The door is balanced, lubricated and run through the opener's safety-reverse test.

FAQ

Broken Spring Repair Questions

Is it safe to open the door with a broken spring?

No. Without the spring the full weight of the door is on the opener or on you, and it can drop suddenly. Leave the door where it is and keep the car inside until it's repaired.

Can I replace a garage door spring myself?

We strongly advise against it. Torsion springs hold enough tension to break bones, and DIY winding with the wrong tools is a common cause of garage injuries.

How long does spring replacement take?

Most residential spring replacements are finished in a single visit once the technician has the right springs on the truck.

Should I upgrade to longer-life springs?

If your garage is your main entrance, higher-cycle springs often cost a little more up front but last noticeably longer. Ask the technician to price both options.

Talk to a local technician today

Call for same-day broken spring repair in Columbus.

Call (380) 666-6240
Call Now